Make Face Edge

The Make Edge tool looks like this Tool and is located on the Modify Tab of the Toolbar. The Make Edge tool is used to split a Primal face and operates on two points within the same face. Click the Make Edge button. Geodesica prompts you to pick the first point. Geodesica prompts you to pick the second point. A new edge appears between the points. A warning dialog will appear if:

1. The second point belongs to another face.
2. The second point belongs to the Dual.
3. The second point belongs to an edge of the first point.

In which case Geodesica prompts you to pick the second point again.

jpg

Non coplanar face created with the 'Kill Vertex' and 'Kill Edge' tools

jpg

Non coplanar face divided up with the 'Make Edge' tool